SPA Waist Jet Chrome Plated Brass Head Shower Combo Panel Massage Function

This shower panel brings the SPA format into a standard bathroom wall: one chrome plated brass frame carries a 200 mm overhead rain head, a hand shower on a sliding rail and four adjustable waist jets that can be angled to work on the lower back or shoulders. All four functions are fed from a single thermostatic mixer at the base of the panel, so the user sets the temperature once and switches outlets with a diverter, without reaching above head height.

The frame is made from brass tube rather than stainless steel, which keeps the joints rigid and prevents the panel from flexing when the hand shower hose is pulled. Two fixing brackets spread the load across the wall and can be adjusted after the tiles are finished, so a slight out of plumb wall does not translate into a crooked panel. Massage jets have rubber nozzles that can be twisted to change the spray pattern and can be descaled by hand, which matters in markets with hard water.

• Four adjustable waist jets: Each jet swivels through 30 degrees so the spray can be aimed at the lower back, shoulders or neck depending on the user height.
• Overhead rain head: The 200 mm head gives a full coverage spray at 9 litres per minute, enough for a SPA feel while staying within common water efficiency limits.
• Thermostatic base mixer: Temperature is set once at the base of the panel and held within plus or minus 1 degree Celsius while the diverter switches between functions.
• Brass frame construction: A brass tube frame keeps the panel rigid and stops the flexing that appears in thin stainless frames when the hose is pulled.
• Adjustable wall brackets: Two brackets can be aligned after tiling, compensating for up to 10 mm of wall variation and avoiding crooked installations.
• Hand shower on rail: A slide rail allows the hand shower height to be adjusted for children or seated users, extending the usable range of the panel.

The panel is designed for residential shower rooms, hotel spa suites, gym and club changing rooms, and short stay apartments where a complete shower experience has to be installed on a single wall without building a wet room. It also suits retrofit projects because the pipework only needs one hot and one cold supply at the base.

Options include a matching white or matte black frame finish, a 300 mm rain head for larger shower areas, and a version without waist jets for budget projects. We can pre assemble the panel with the mixer tested and the hose fitted to reduce site labour.

The panel is packed in a reinforced carton with foam blocks at both ends and a cardboard spine along the frame, so it survives container stacking. Mixer, hose, hand shower and fixing kit are in a separate accessory box inside the carton, and each carton is labelled with model, finish and panel length.

Every panel is assembled and leak tested at 1.6 MPa before packing, and the thermostatic cartridge is calibrated so the safety stop is verified. Chrome surfaces are inspected under daylight lamps and protected with a peel film before the carton is closed.